Application issues and improvement targets
- Long cooling time
- Warping after moulding
- Sink marks and dimensional mismatch
FM 101 / 2005 / 201 / 301
Dimension & Cycle Control Masterbatch
For cycle time, shrinkage and post-moulding deformation.
A solution family for PP and PE parts affected by long cooling cycles, shrinkage, sink marks or post-moulding deformation.
SELECTION NOTES
Selection criteria and application conditions
We confirm the grade and addition route against the resin, equipment, product structure and acceptance criteria. The information below defines the initial application fit.
Trial and validation criteria
- Improve mould-release and cycle efficiency
- Control shrinkage and post-deformation
- Support stiffness and surface quality
COMMON APPLICATIONS
Typical applications
01Appliance housings
02Caps & closures
03Pipes & fittings
04Daily-use products
MATCHED PRODUCT ROUTES
Application routes for different products and processes
One functional system may serve different products. Each route identifies the polymer, process, target criteria and matched supply.
01Plastic parts
Moulded appliance, household and structural parts
Start from part geometry, resin, tooling and cycle, then match dimension, clarity, toughness, antibacterial or surface functions.
- Applications
- Appliances · Household goods & toys · Automotive & structural parts
- Key needs
- Warping, shrinkage & cycle · Clarity, gloss & heat · Impact & low temperature · Antibacterial & surface function
- Matched supply
- Part sampling or finished-product cooperation · Functional masterbatch · Formulation & production introduction
TECHNICAL DOCUMENTS
Request TDS, MSDS or a sample
This public page supports initial selection. Detailed TDS, MSDS and grade-specific documents are provided by email after we confirm the application, resin system and sample requirement.
This page is for initial assessment only. We do not guarantee a result for a specific part from the product name alone. Model, dosage, test method and compliance requirements follow trials and agreed technical documentation.